Page 1 of 1

File System registration of protected DLL question

Posted: Mon Jun 08, 2015 4:54 pm
by mqsymth
In using the file system registration for my protected DLL, I used %DEFAULT FOLDER% and I put the relative path as MyRegKey.dat in the "Relative Path In File System" box when I protected the DLL. After generating the key using the Key Generator, I placed the file MyRegKey.dat in the same directory as the protected DLL but the DLL is not reading this file and terminating.

Here is a copy of MyReKey.Dat
[Registration information]

I'm using Hardware protection with CPU, Motherboard and harddisk serial number protection.

What am I doing wrong here?

Re: File System registration of protected DLL question

Posted: Tue Jun 09, 2015 6:01 pm
by mqsymth
The problem occurs when the time trial expires.

I have the "Use Limitation By Expiration Date" Checked. I set the expiration to 6/5/2015 (today is 6/9/2015). I have the "Termination Execution After" checked and set to 0. If I uncheck this the DLL runs despite being past the expiration date

Under " Registration Features" -> Hardware Lock I have the "Hard Disk Serial Number" Checked.

Under "Registration Data Storage" I have "Use File System" checked, I used %DEFAULT FOLDER% and under "Relative Path in File System"
I put \MyRegKey.dat

Since I changed the registration features to "Hard Disk Serial Number I create a new License.
[Registration information]

When I put both the license and the DLL in the same directory. the DLL does not recognize the license and stops.

What Am I doing wrong